2

I had a damaged disk, I didn't know that. But after some use, other problems started to appeared. So I just replaced it because of it failures.
So what are the most common causes of Block failure? And why hardware can't ignore the damaged Block (sometimes applications crashes, BIOS can't boot from that disk, or Windows cannot properly install)?

2 Answers 2

2

The two main causes of damage (whether that be at block level or anything more significant) are:

  • Manufacturing errors - the problem may be there from the outset or may appear after some time/use
  • Impact damage - disks can only withstand shocks up to a certain tolerance before damage is likely to occur.

If you have one or more bad block, the disk will usually detect this and try to recover information which will be moved to one or more spare blocks. The original block will be marked as 'bad' and will no longer be used. Of course, depending on the problem, this data recovery may not be possible - hence the problems you describe. Equally, there are a finite number of spare blocks, and once these have been filled, your problems will accelerate.

While you can sometimes live a small number of bad blocks, it is usually the start of a slippery slope, so it is best seek a replacement disk - if your disk is within it's warranty period, you may find you can get a free replacement - I have successfully RMA'd several disks because of bad blocks.

Most modern disks support SMART - which can give warnings of disk hardware problems, and there are plenty of tool, such as HD Tune what can check SMART information, run surface checks (for bad blocks) and measure performance.

2

Making it very simple and kind of inaccurate, a hard disk is basically a set of one or more magnetic rotating platters which are read by a head that is managed by a controller (not the SATA controller of your mobo, a controller into the disk itself).

I don't know all the possible reasons why a block of a magnetic platter can become 'damaged'. I heard that, when the disk suffers some physical stress, the head can crash on the platter (they are very close!) damaging the incredibly fragile magnetic film which is on the platter itself.

Also, a defective manufacturing of the magnetic platter can soon bring to read failures.

A 'damaged' sector either cannot be read at all, or at least, it can be read but with frequent read errors -- so that it is considered 'unreliable'. The disk controller (if it works -- and sometimes it can be damaged or defective itself) can recognize sectors which are impossible or hard to read/write and mark them as 'damaged', so that they won't be read or written anymore. Modern disks recognize and isolate bad sectors without you knowing and often without you losing any data. So I'm a bit surprised you had so many problems. Maybe the disk was very old so that it didn't implement proper bad sectors handling, or the controller was defective, or the head itself was screwed, or there were so many bad sectors that using the disk became impossible.

However I'm fine and happy with a disk of mine which has 15 bad sectors. I do backups often, obviously.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .