Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I am working with a RangeMax(TM) Wireless Router WPN824 v2, and it will not allow a wireless connection nor a wired connection.

I am at an actual lost, with no way into the router I cannot test settings. I have unplugged it, left it off for a 32 hours, and reset it with no luck.

Any ideas? Could the router just be done-zo?

share|improve this question
    
Now I have finally got it to reset, but a new problem develops. The wireless does not work (I assume its off by default), but upon connecting to the router it claims (in a browser) that the device is controlled by 192.168.1.2. There is no device with this IP address on the network. There is no access to the web control panel located on the router. –  Chris Feb 17 '10 at 2:36
    
What is the IP address your computer gets from the router? –  heavyd Feb 17 '10 at 2:46
add comment

3 Answers

If you have tried resetting the router without any success could be a hardware problem with the device. Have you also checked the cable that runs from your modem to your router and confirmed that the cable is good?

share|improve this answer
    
+1. Hard reset router (with reset switch) then log in again. If it still says someone is managing it, RMA it. –  RJFalconer Mar 30 '10 at 8:35
add comment

Are you in the ip range 192.168.1.x ? The default IP of the router is 192.168.1.1 so, the first time, you must have an ip in this range to set up it.

The message that say that the device is controlled by is 192.168.1.2 is odd, may be it has already been hacked? What's the status of the wireless led?

share|improve this answer
    
The wireless LED doesn't even turn on. The only thing that shows up is a check mark to the far left of the device. I am in the 1.x subnet so the device recognized my presence, but gives me the 192.168.1.2 controller error. –  Chris Feb 18 '10 at 19:35
1  
I don't see what it could be... Double check: Unplug everything except you, reboot (unplug / wait a little / plug the power cable) or reset it (insert something in the little hole in the back for 15 seconds, when it's powered on). And try again –  fluxtendu Feb 19 '10 at 6:48
add comment

Do network cables connected to it show as "Connected"?

The only way I can think of to check if it's completely f**ked is to plug the WAN port into a computer, start Wireshark on that NIC, and power it up. If it's working, you should see some DHCP activity as it tries to retrieve an IP from your ISP.

If it doesn't do that, it's probably a hardware failure.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.