0

I have AT&T U verse with Router as

Manufacturer Pace Plc Model 5268AC

Default router address is 192.168.1.254

I would like to change it to 192.168.1.1

Regards

3
  • What does the manual say?
    – Ramhound
    Jul 20, 2016 at 23:58
  • Based on my research, your device, does not allow you (the end user) configure the intranet address it is assigned.
    – Ramhound
    Jul 21, 2016 at 0:01
  • ARRIS product firmware is always handled by your ISP. If there isn't an option to change it when you navigate to 192.168.1.254 then it cannot be changed. AT&T nor ARRIS provide a manual, and the manual for Surfboard makes no mention of that capability. (Relative because its all the same firmware basically)
    – Ramhound
    Jul 21, 2016 at 0:05

1 Answer 1

1

If what you have is the same Pace 5268AC described here then page 20 of the linked manual indicates that you can customize the LAN settings on the Settings / LAN / DHCP page:

  1. If you selected Configure manually, enter the following information:
    • Router Address. The LAN IP address of the gateway.
    • Subnet Mask. The subnet mask of the gateway (default: 255.255.255.0).
    • First DHCP Address. The first IP address in the DHCP IP address pool to be assigned on the local network.
    • Last DHCP Address. The last IP address in the DHCP IP address pool to be assigned on the local network.

In your case, change the Router Address from 192.168.1.254 to 192.168.1.1.

2
  • currently it's using router as DNS, do you know where i can set it to assign the att DNS as DNS on DHCP machines. I looked all pages and still unable to find the setting
    – SeanClt
    Jul 21, 2016 at 1:50
  • 1
    @SeanClt The router (which is itself a DHCP client on the WAN/broadband side) obtains the DNS from AT&T. On the LAN side, the router likely distributes its own local IP for client DNS, which is fairly common. I don't see an option in the config pages for this model to control/override that.
    – dxiv
    Jul 21, 2016 at 2:19

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .