19

I'm replacing the heatsink on my CPU, and want to clear the current thermal paste.

What should I do?

0

4 Answers 4

17

Use rubbing alchohol. It cuts the grease and dries quickly/safely for electronics.

The preferred way to remove typical silicone oil-based thermal grease from a component or heat sink is by using isopropyl alcohol (rubbing alcohol). If none is available, pure acetone is also a valid method of removal.

From Wikipedia

Also the suggestion to use a credit card/business card to scrape off the paste first is a good idea.

1
  • 2
    I would NOT use rubbing alcohol as it contains perfumes and oils intended to ease the discomfort (the odor, and the extreme skin drying) of an alcohol rub. (This is also why I never used it to clean tape heads.) Instead I use alcohol labeled as "isopropyl alcohol" (IPA for short). Drugstores sell it OTC at both 91% and 99% concentration. Jul 30, 2017 at 9:22
7

I have always scraped it off with a credit card, then used alcohol applied with paper towels and a q-tip to clean the residue.

Wikipedia has more detail though:

Computer processor heatsinks utilize a variety of designs to promote better thermal transfer between components. Some thermal greases have a durability up to at least 8 years. Flat and smooth surfaces may use a small line method to apply material, and exposed heat-pipe surfaces will be best prepared with multiple lines.

Excess grease separating the metal surfaces more than the minimum necessary to exclude air gaps will only degrade conductivity, increasing the risk of overheating. Silver-based thermal grease can also be either slightly electrically conductive or capacitive; if some flows onto the circuits it can cause malfunctioning and damage.

Over time, some thermal greases may dry out, have reduced heat transferring capabilities, or set like glue and make it difficult to remove the heat sink. If too much force is applied the processor may be damaged. Heating the grease by turning the processor on for a short period often softens the adhesion. Another method to use can be by turning the heatsink slowly instead of lifting it up. It is recommended that thermal grease be re-applied with each removal of the heatsink.

Silicone oil-based thermal grease can be removed from a component or heatsink with an alcohol (such as rubbing alcohol) or acetone. Special-purpose cleaners are made for removing heatsink grease and cleaning the surfaces.

1
  • 5
    just be careful not to leave fibers from the paper towel or q-tip. Apr 17, 2010 at 14:36
3

Here is a YouTube video on how to clean off thermal paste from a CPU. Granted it only shows you how to clean a CPU that has already been removed.

I recently bought two Xeon CPUs off of eBay and the thermal paste got onto contact pads. In the video I used 91% isopropyl alcohol and cotton swaps to clean both the underside and top side of the CPUs. At the end I show as a proof of concept that the CPUs still work.

https://www.youtube.com/watch?v=UhyMdkOUtV4

1
  • 2
    I added a small summary to this answer. Jun 8, 2015 at 22:17
0

I just removed a heatsink from a computer and tried to remove the old thermal interface material (TIM) from it.

First I sprayed some 99.9% isopropyl alcohol onto the heatsink and tried to wipe off the TIM, and it had no effect. I tried a few more times to no avail.

Then I sprayed some CRC QD Electronic Cleaner that I got from my local home improvement store onto the TIM, and that worked. It still took several rounds of spraying and wiping, but eventually it all came off.

Since their web site says the product is safe for computer components, I also used it to clean the CPU.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .