Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I purchased a PowerColor HD 5770 video card so I could get a third monitor working. I have two widescreen monitors, one attached via HDMI and the other attached via DVI. My third monitor is attached from DisplayPort to VGA (using a passive connector like this one)

The third monitor is a 19" Hyundai L90D. I was unable to find any Windows 7 (or Vista for that matter) drivers for the monitor, so it's stuck with "Generic Non-PNP Monitor". It's native resolution is 1280 x 1024. Randomly Windows will boot up in the correct native res, but sometimes it boots up in 640 x 480 res. When it does boot up into 640 x 480 res, the screen resolution slider is stuck and I cannot slide it back to 1280 x 1024.

I cannot find a pattern for when or why it will do this, I've tried rebooting five or six times in a row at times to get it to boot into native res, but this doesn't always work.

share|improve this question
    
what happens if you use your DisplayPort converter (it is actually active not passive, otherwise you can only operate two monitors) on the other monitors? –  icelava Jun 15 '12 at 7:33

2 Answers 2

Check the monitor properties. Is "Hide modes that this monitor cannot display" checked? Perhaps that is preventing you from using the slider.

share|improve this answer
    
The checkbox for this is grayed out, but it is not ticked. I cannot toggle it either way, though. –  ajbdev May 4 '10 at 20:12

Sounds like either through the cable conversion process (DP to VGA) or due to the quality of Hyundai (or both), Windows 7 is not getting the information it needs about the monitor on boot-up - the monitor is not transmitting its EDID ("Extended display identification data").

Two ways you could correct that:

  1. Manually run a scan for new hardware or displays in Catalyst Control Center or Windows 7.

  2. Script-force Windows 7 and / or CCC to scan for displays on boot-up. Windows Task scheduler is an excellent tool, but before that I would check into CCC's settings.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.