Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have a friend with a broken iBook, but we wish to recover the hard disk. I haven't seen the drive itself, however the spec lists it as an "Ultra ATA drive". Could you please advise if this is 100% compatible with any standard USB IDE 2.5inch enclosure?

Full spec:

iBook 12" 1GHz(AP) 256MB DDR266 SDRAM built-in Keyboard/Mac OS X Bluetooth Module 40GB Ultra ATA drive Combo (DVD-ROM/CD-RW).

share|improve this question

1 Answer 1

up vote 2 down vote accepted

"Ultra ATA" is "standard IDE" so yes, it should be 100% compatible with any modern USB-to-IDE adapter or enclosure.

See Wikipedia's Parallel ATA article for the full history. IDE (Integrated Drive Electronics) was developed by Western Digital, and evolved into the AT Attachment Interface (ATA/ATAPI). Most "IDE" drives you'll see nowadays are actually "EIDE" drives (Enhanced IDE) -- this just means they meet the specs of some version of ATA/ATAPI, usually between ATA-2 and ATA-6.

Note Wikipedia's ATA standards table:

  • pre-ATA was also known as IDE
  • ATA-1 aka ATA, IDE
  • ATA-2 aka EIDE, Fast ATA, Fast IDE, Ultra ATA
  • ATA-3 (ditto)
  • ATA/ATAPI-4 aka ATA-4, Ultra ATA/33
  • ATA/ATAPI-5 aka ATA-5, Ultra ATA/66
  • ATA/ATAPI-6 aka ATA-6, Ultra ATA/100
  • ATA/ATAPI-7 aka SATA/150, SATA 1.0, Ultra ATA/133

Check the drive's label for one of the above standards, then make sure the USB enclosure you're considering supports that level. They are backwards-compatible, so if you don't get exact matches, the slowest speed will be used. (Eg, if you have an ATA-2 drive and an ATA-6 enclosure, it will only use ATA-2 speeds. Since this is a USB enclosure, this limitation won't matter much.)

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.