Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Is there a command that i can issue in Ubuntu to see explicitly if my ethernet controller supports gigabit ethernet?

share|improve this question
add comment

2 Answers 2

up vote 11 down vote accepted

As root, run ethtool eth0 if eth0 is the NIC in question. You'll get an output like:

Settings for eth0:
Supported ports: [ TP ]
Supported link modes:   10baseT/Half 10baseT/Full 
                        100baseT/Half 100baseT/Full 
                        1000baseT/Half 1000baseT/Full 
Supports auto-negotiation: Yes
Advertised link modes:  10baseT/Half 10baseT/Full 
                        100baseT/Half 100baseT/Full 
                        1000baseT/Half 1000baseT/Full 
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: g
Current message level: 0x000000ff (255)
Link detected: yes

Should be all the info you need.

share|improve this answer
    
Cool, didn't knew about that. –  whitequark Jun 8 '10 at 15:01
add comment

lspci should show it like "blah blah Gigabit 10/100/1000 blah blah controller". Like that. :)

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.