Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Do I have to apply more thermal paste to put the processor heat sink back into the laptop? OR, do I just need to make sure that the screws are tight, and it will work? What are the problems with not applying more paste?

Also, if I do need to do so, how do I apply it? Just put some on and stick it together? Thanks!

share|improve this question

3 Answers 3

up vote 6 down vote accepted

You need to be careful you don't over-tighten the screws, that could lead to a cracked heat sink or even CPU.

If the heat sink has come/been taken off your safest approach is to carefully clean the old paste off both parts an apply fresh.

It can't be stressed enough that there needs to be good thermal conductivity between the CPU and the heatsink as processors generate a lot of heat.

share|improve this answer
3  
And, don't cake it on, either. Too much paste is as bad too little since that can create small pockets of air between the CPU and heat sink. –  Michael Todd Jun 26 '10 at 21:44

Applying thermal paste is not that hard, there are different application methods depending on if the CPU has a heatspreader built on it or if the core is exposed.

If the core is exposed I suggest using this guide from Arctic Silver: http://www.arcticsilver.com/pdf/appmeth/int/ss/intel_app_method_surface_spread_v1.1.pdf

If the core has a heatspreader on it: http://www.arcticsilver.com/pdf/appmeth/int/vl/intel_app_method_vertical_line_v1.1.pdf

The application is the same on AMD CPUs.

And to answer your other question, yes it is really necessary to use thermal paste, with thermal paste you make sure there is contact between the two surfaces leading the heat to the heatsink. Without thermal paste you might experience very high temperatures which in the worst cases can lead to breakdowns and permanent CPU damage.

Also remember to thoroughly cleaning your CPU die, I recommend using 90%+ alcohol and clean all the old paste of it using q-tips or some pads.

share|improve this answer
    
How do I tell if it has an exposed core or a heatspreader?? –  studiohack Jun 26 '10 at 21:53
2  
Exposed core will look like this: techspot.com/fileshost/newspics2/2009/intel-core-i5-mobile.jpg and one with a heatspreader will look like this: easycom.com.ua/data/news/0910201938/img/… –  Cheesebaron Jun 26 '10 at 21:58
    
now I am really confused as to what my heatsink is supposed to look like?? what is the difference between the two photos? –  studiohack Jun 26 '10 at 22:16
3  
If you look at the last image, the CPU dies have a metal cover opposed to the first one. That metal cover helps spreading the heat to the heatsink, mostly mobile CPU's does not have that. It is obvious that the heatspreader has more surface to apply thermal paste to, so the methods on applying differ and the amount of thermal paste is also different from one method to the other, because too much thermal paste gives you the opposite effect, it will isolate the heat instead of transporting it to the heatsink. –  Cheesebaron Jun 27 '10 at 6:26

My question at this point is: what kind of processor chip do I have? Is it an exposed core or a heatspreader? what is the difference? How do I tell?

Speccy can help you to determine which processor chip you have and much more.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.