up vote 16 down vote favorite
1
share [g+] share [fb]

When installing Windows XP, there is a prompt for formatting the disk. What is the difference between an NTFS 'format', and an NTFS 'format (Quick)'?

link|improve this question
89% accept rate
feedback

3 Answers

up vote 16 down vote accepted

It depends.

If it's a disk that has been working fine, just use the quick format, otherwise I'd do a full format, which also scans for bad sectors.

More info here: KB302686.

link|improve this answer
6  
but then, I would never use a disk I knew to be faulty for a fresh installation, so .... – Lasse V. Karlsen Jul 15 '09 at 13:32
In other words, there's no point to spending extra time scanning for bad sectors at format time, because the OS has to do that on reads/writes anyway. You don't save any work later, and you get nothing now because even if it finds a bunch of bad sectors you didn't already know about it will still just mark them bad and move on. – Joel Coehoorn Feb 17 '11 at 20:06
feedback
up vote 1 down vote

I always use quick format.

There is just no reason for a long format in modern harddisk, since writing each block to zero won't do any good to "fix" any actual harddisk problems. These days, harddisk either work, or it needs to send it for RMA, or just dump it.

link|improve this answer
feedback
up vote 0 down vote

Quick format, because one time it gave me an error and I thought if I did it in format it would work, after waiting hours it gave me the same message. :(

link|improve this answer
feedback

Your Answer

 
or
required, but never shown
discard

Not the answer you're looking for? Browse other questions tagged or ask your own question.