Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Are these readings ok? that +2.5v is the DDR's?

+2.5V:   1,45V
Vcore:   1,51V
+3.3V:   3,26V
  +5V:   5,14V
 +12V:   12,11V
share|improve this question
1  
FWIW, the voltages reported by most tools (CPU-Z, etc.) on my EVGA motherboard are total rubbish, systematically wrong by a volt or two. The voltages reported in the BIOS, however, are reasonable looking. I wouldn't trust anything short of a Fluke to mean much. –  coneslayer Jul 27 '10 at 19:50

1 Answer 1

up vote 1 down vote accepted

There is no 2,5V PSU line. Motherboard takes care of voltage conversion for that.

In my opinion, 1.45V is problematic, but it may not be related to PSU. Get some other program which can display more voltages and show us the results. Also take a look here and here.

Also, which version of DDR is that? If it's DDR3, than it's good. If it's 2 or 1, it's a big problem.

share|improve this answer
    
It's DDR1, last December 4 RAMs just died, could that be the reason? Other readings show the same 1.43 ~ 1.45. It's the mobo then? Everytime I start the PC i hear some "electric noise" coming from the PSU and when something uses the graphic card (windows 7 loading logo) the PC shuts down. After the BIOS tells me there was a problem it just run smoothly, basically I've to start the PC twice or more times, after that it can be on until I decide to turn it off. –  Ben Jul 27 '10 at 22:36
1  
I think (but I could be wrong!) that you have problems with bad capacitors. The fact that you need to start computer multiple time in order for it to start working correctly makes me think that this is the problem. It could be bad capacitors on motherboard, in power-supply or both. Open the case and take a look at them. If they look like something from here: en.wikipedia.org/wiki/Capacitor_plague then that's the problem. Otherwise, try to obtain a known good PSU and start your system with it and check voltages. If they are still bad, then it's motherboard. Otherwise it's PSU. –  AndrejaKo Jul 27 '10 at 22:44

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.