Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have a Samsung monitor stand that I got off of a monitor similar to this one. I was thinking I could get an adapter plate (75 to 100 VESA adapter) and use that stand for one of my other monitors that's not height adjustable.

However, the stand's adapter plate has two screws and two tabs. It looks like it'll be tough to use with an adapter plate, since the plates have four screws for the stand side and four for the monitor side.

Is it possible to re-use this monitor stand?

I can supply pictures if needed.

share|improve this question

1 Answer 1

up vote 1 down vote accepted

How good are you at fabricating? Drill and tap the adapter plate to match the four hole pattern.

share|improve this answer
    
The problem is that there isn't a 4 hole pattern on the stand, as I explained. Also, those plates are easy to buy and cost about 20 bucks. –  jcollum Sep 15 '10 at 18:43
    
Can you drill the stand? When you need a hole, make one. I've had to do this on countless pieces of networking equipment and bays to fit things where ILECs have wanted them in COs. Usually everything can be drilled if its just a matter of lining up holes. –  MaQleod Sep 15 '10 at 22:28

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.