up vote 0 down vote favorite
share [g+] share [fb]

I have set up QoS on an IPFire install acting as a router at the gateway to my home LAN. I am using only the default QoS settings, which are meant to function quite well.

When QoS is diabled, the network functions as expected When I turn on QoS ALL traffic between the Red and Green interfaces (internet-facing and inward-facing respectively) stops. Has anyone encountered this problem before?

link|improve this question
feedback

1 Answer

up vote 0 down vote accepted

QoS needs correct setting for Up/Downlink speed. After this you have to click on "preset" to calculate the default classes based on you link speeds. if this settings are wrong it may block the whole traffic.

http://wiki.ipfire.org/en/configuration/services/qos

link|improve this answer
Thanks for the response, I tried entering those values in both kBit and kByte, same result each time. – Jeremy Oct 14 '10 at 23:48
Ok, just tried again and it's working flawlessly. I guess that's what you get for trying to set up new services on your router at 3am! – Jeremy Oct 14 '10 at 23:54
feedback

Your Answer

 
or
required, but never shown
discard

Not the answer you're looking for? Browse other questions tagged or ask your own question.