Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have run out of SATA ports on my motherboard. But I have a free eSATA port that I can convert using an eSATA/SATA converter cable & direct the cable back into the case. Does anyone have any comments on if it makes sense to use the eSATA port to this HDD caddy?

I have a suitable power connector from the power supply (PSU) to plug into the caddy. This drive will probably be a boot drive.

Antec 600 case

share|improve this question
add comment

2 Answers

up vote 1 down vote accepted

The only differences between Sata and eSata are the connector style and eSata cables are shielded. It should work. You may have problems when you connect it while booted if AHCI is not enabled in the bios and software is not installed for it.

AHCI allows for hot plugging of Sata.

If AHCI is not enabled in the bios or does not have the option to use it, that is a whole other problem to solve, you will have to connect and power up the external drive before you Boot the PC if AHCI is not enabled or not available.

share|improve this answer
add comment

It's a little bit of a kludge, but I don't see any reason it shouldn't work fine. Some motherboards do have the eSATA ports on a different controller which can hurt performance and/or impair your ability to boot from the drive but PROBABLY it should work. I think it's a pretty clever use of the resources you have handy.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.