Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

How do I fix the "Dirty bits not set" error if I'm using a FAT32 system? I'm aware of the fsutil tool but apparently, it doesn't do it's job well on FAT32. Is there an alternative 3rd party software around? Can I fix it manually? Thanks a lot to those who'd answer!

share|improve this question
    
Could you be more specific about the error message and the circumstances where you are getting it? –  harrymc Oct 28 '10 at 13:34
    
I'm getting the error whenever I try to load a game called Dead Frontier which runs absolutely fine on all other machines I've tested it in. Be it lesser in specs than the above unit or not. –  Registered User Nov 1 '10 at 9:33
add comment

1 Answer

up vote 0 down vote accepted

The best tool I'm aware of for analyzing and fixing low level problems in the dos/windows formats & environments is: http://www.grc.com/spinrite.htm

If it doesn't resolve the issue you probably have a hardware failure on your hands. I'd highly, highly recommend backing up anything/everything you can before you run any analysis/recovery software. In my experience with hardware failures they get worse and worse the more the disk runs, so you have a limited amount of time that the drive is on to get stuff off.. DO NOT write anything to the disk - read/backup stuff off it only. Then try spinrite to see if you can fix things that way. Sometimes it's just a bad sector that crops up and that doesn't compromise the whole disk..

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.