up vote 1 down vote favorite
share [g+] share [fb]

I received a DigiPro/UC-Logic WP5540 tablet today. While the hardware seems fine (as determined thanks to the default drivers Windows installed), using the manufacturer's drivers (v5.02, 2010-06) resulted in an inverted Y axis, and erratic movement (including some inversion, and some pronounced Y motion, but not always) on the X axis.

I'm running Windows 7 Ultimate x64.

Anyone else with this model of tablet have this problem before and figured out how to fix it? Going back to the default drivers doesn't count as I require the pen pressure ability (which the default driver doesn't support).

link|improve this question
100% accept rate
Do you by chance have a multiple monitor setup? – MaQleod Oct 30 '10 at 1:58
Nope, it's a laptop without any other monitors or projectors plugged in. – Chris Charabaruk Oct 30 '10 at 2:10
Turns out it was a hardware issue of a kind; for anyone else with a WP5540 and having spastic control issues, try replacing the pen battery! – Chris Charabaruk Oct 30 '10 at 2:11
Some 9 months later, and the problem is back, even with good batteries. :( – Chris Charabaruk Jul 25 '11 at 20:57
feedback

2 Answers

up vote 0 down vote

I have the same tablet, and I'm using the default windows 7 driver. And it seems to work great.

link|improve this answer
feedback
up vote 0 down vote accepted

Check the pen battery, the drivers work fine.

link|improve this answer
feedback

Your Answer

 
or
required, but never shown
discard

Not the answer you're looking for? Browse other questions tagged or ask your own question.