Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have a LG L204WT which has VGA and DVI connectors. Until recently, I have used the monitor via VGA, but now I have upgraded the graphics board and switched to DVI.

The problem is that each time after the computer starts, the monitor either doesn't show anything (black screen, but doesn't go into standby) or the picture is distorted.

I then switch the monitor off and on several times, and at some point it starts correctly and then I can work as usual. This only happens on startup.

It is one out of 3 monitors, the other two work fine.

It seems to me as if the monitor is not able to synchronize on the DVI signal and either shows a distorted picture or nothing at all. There are no settings in the monitor setup that would change anything.

What could be the problem?

share|improve this question

1 Answer 1

up vote 0 down vote accepted

The only help is to use the VGA-connection. No way so far to make DVI work.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.