Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I'm going to install Windows XP from a CD and want to make sure it calls the partition it lands on C:. The target partition is the first one on a SATA disk, which is not the first one in my computer. There's no IDE disk there.

I don't think I can swap the disks, as I'm using a fake RAID and really don't want to get problems with it. The target partition is on a normal disk.

I know it may be unimportant, but I don't want to run in any problems I can avoid. I've seen a question slightly related to it, but I'm not going to install from a USB.

share|improve this question
1  
Its always wise to disconnect all but the target drive prior to a XP install. –  Moab Feb 2 '11 at 17:07

1 Answer 1

If you install from a CD, it should land on C: by default. Just pick the hard drive, even if it's a RAID system (should just see the RAID in the installer), and you're good to go. The only time I've ever seen it pick D: is when installing from a flash drive (because then the drive takes C, so D is the next letter up).

share|improve this answer
1  
I've seen issues when you have a card reader installed. It will install xp on another drive letter. The solution to that is to just unplug the reader during the partitioning phase. –  piagetblix Feb 2 '11 at 14:39
    
It's not true, I tried it and Windows calls it's installation partition I:. I really do hate it. –  maaartinus Feb 6 '11 at 14:38

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.