Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have 3 SATA drives - 1 SSD and 2 common HDDs. After changing HDD controller mode to AHCI and installing Windows 7, I still have choice to safely remove HW devices - disks. Every time I'm going to remove USB flash card I worry that I accidentally turn off system drive (is it even possible?). Is it possible to turn off this feature for those 3 HDDs?

share|improve this question
    

1 Answer 1

up vote 1 down vote accepted

http://www.eggheadcafe.com/software/aspnet/30495127/remove-hardware-from-safely-remove-hardware-list.aspx

Not sure if this method can be adapted to non USB devices. Disk drives should show up under HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum\IDE .

This can be achieved by modifying a registry value. So far I had no time writing a little tool for this...

Devices are shown there if they are marked as removable and if they do no have the 'surprise removal ok' flag. These are bit coded flags:

From cfgmgr32.h:

The device capabilities are found in the registry in a value named 'Capabilities' under (sample for one of my USB flash drives): HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum\USB\Vid_058f&Pid_6331\058F091111B

If you take away 4 from the value or add 80h and then refresh the save removal dialog by toggeling the checkbox, then the drive is gone. But the value is reset when you attach the drive for the next time. This is hard coded into the driver and read each time the drive is loaded. If you export the modified value an reg file then you can silently load it on startup by regedit /s hidecardreader.reg

The device id string of your card reader (this Vid_058f&Pid_6331\058F091111B thing) is found in the properties of the USB device in the device manager. My ListUsbDrives tool shows it too (the 'Ctrl DevID'): http://www.uwe-sieber.de/files/listusbdrives.zip

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.