Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I need a serial port monitoring software that works on windows 7 64bit or GNU/Linux and supports at least RS-232. Bonus points are if it's free software or at least freeware. I just need to be able to see what goes in and what goes out of the port. At this time, I don't need any protocol deciphering or anything else complicated.

Any ideas on what could work?

share|improve this question

closed as off-topic by Nifle, DragonLord, fixer1234, random Feb 2 at 4:29

This question appears to be off-topic. The users who voted to close gave this specific reason:

  • "Questions seeking product, service, or learning material recommendations are off-topic because they become outdated quickly and attract opinion-based answers. Instead, describe your situation and the specific problem you're trying to solve. Share your research. Here are a few suggestions on how to properly ask this type of question." – Nifle, DragonLord, fixer1234, random
If this question can be reworded to fit the rules in the help center, please edit the question.

    
    
@Olli Thanks a lot! That fixes the GNU/Linux side of the problem. –  AndrejaKo Feb 8 '11 at 12:18

2 Answers 2

On Windows machines, I've always used HyperTerminal (hypertrm.exe) to monitor serial ports. For my 32-bit Vista install, I copied over hypertrm.exe and hypertrm.dll from my old XP install and it worked just fine.

I don't have a 64-bit Windows 7 install, so I can't check that it would work for you. So it might need XP compatibility mode or some other 32-bit mode to work.

This person got it to work on Windows 7 32-bit. Also on that site is a list of more HyperTerminal replacements for Windows 7, though it focuses much more on the other communication protocols done by HyperTerminal.

Several other HyperTerminal replacement ideas are listed here.

share|improve this answer
    
Can hyperterminal show status of each pin on the port? –  AndrejaKo Mar 5 '11 at 16:06
    
I don't have a setup handy to check it out, but I believe the status bar displays active pins CTS, DSR, etc. –  yhw42 Mar 5 '11 at 16:20

I know only software that works on Windows 7 x64. And supports RS232/485/422 COM port. http://www.eltima.com/products/serial-port-monitor/

I didn't work on Linux/GNU and don't know any good soft to monitor serial port.

share|improve this answer

Not the answer you're looking for? Browse other questions tagged or ask your own question.