Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I need a serial port monitoring software that works on windows 7 64bit or GNU/Linux and supports at least RS-232. Bonus points are if it's free software or at least freeware. I just need to be able to see what goes in and what goes out of the port. At this time, I don't need any protocol deciphering or anything else complicated.

Any ideas on what could work?

share|improve this question
    
    
@Olli Thanks a lot! That fixes the GNU/Linux side of the problem. –  AndrejaKo Feb 8 '11 at 12:18

2 Answers 2

I know only software that works on Windows 7 x64. And supports RS232/485/422 COM port. http://www.eltima.com/products/serial-port-monitor/

I didn't work on Linux/GNU and don't know any good soft to monitor serial port.

share|improve this answer

On Windows machines, I've always used HyperTerminal (hypertrm.exe) to monitor serial ports. For my 32-bit Vista install, I copied over hypertrm.exe and hypertrm.dll from my old XP install and it worked just fine.

I don't have a 64-bit Windows 7 install, so I can't check that it would work for you. So it might need XP compatibility mode or some other 32-bit mode to work.

This person got it to work on Windows 7 32-bit. Also on that site is a list of more HyperTerminal replacements for Windows 7, though it focuses much more on the other communication protocols done by HyperTerminal.

Several other HyperTerminal replacement ideas are listed here.

share|improve this answer
    
Can hyperterminal show status of each pin on the port? –  AndrejaKo Mar 5 '11 at 16:06
    
I don't have a setup handy to check it out, but I believe the status bar displays active pins CTS, DSR, etc. –  yhw42 Mar 5 '11 at 16:20

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.