Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I had an old IDE hard disk with Windows XP Installed. Then I switched to Windows 7 but that was installed on another drive, this time SATA and then I reformatted the drive with Windows XP.

However, the boot information is still on a partition on an IDE drive.

I wanted to remove this drive from my computer (physically) but when I did that, the system wouldn't boot, even though the Windows 7 is installed on a disk that remained in the computer. Obviously, the problem is in that 100 MB NTFS partition on Disk3 (System Reserved).

Is there any solution for this, so I can remove Disk3 IDE from my computer, and that no Windows reinstallation would be necessary.

Note that I have another SATA disk (Disk2) which is still unused. Maybe I could copy/mirror the System Reserved partition to that disk and then remove Disk3. Would that do anything?

enter image description here

share|improve this question
    
I'm not 100% sure, but I have a hunch supergrub will allow you to boot Win7 in your situation. If all else fails give this a go. –  boehj Apr 23 '11 at 14:06
add comment

4 Answers

up vote 2 down vote accepted

I was stuck in a similar situation... These two articles might help you:-

http://www.sevenforums.com/general-discussion/11294-moving-boot-manager-different-drive.html

Moving Windows 7 Boot Files (bootmgr, bootsect.bak, Boot directory) to Different Drive

Basically, for me, the Windows 7's boot manager got stuck in the drive with Windows XP (I heard Windows 7 always install this to the first drive it finds during boot). I followed steps in the two articles above and managed to move it to the drive with Windows 7. I removed the Windows XP drive and Windows 7 managed to boot on its own.

And I also recommend that you backup everything before attempting anything. =)

share|improve this answer
1  
Note from original poster: I have found the solution to my problem on the second link provided. In a few words, I have installed EasyBCD and switched to BCD Backup/Repair and then "change boot drive". This worked perfectly. I have disconnected my IDE drive afterwards and it booted allright. –  Kornelije Petak Apr 24 '11 at 8:34
add comment

Why not create a Windows 7 rescue disk, remove your PATA harddisk, reboot with the Rescue disk and let it repair the boot sector? See if that works.

NOTE: Backup your data before you do anything.

share|improve this answer
add comment

Change your boot order in your system bios so that the Windows 7 hardbdrive is first. Also change your hard drive order in the BIOS. it should boot off the SATA drive then.

share|improve this answer
    
You haven't read the post carefully. The problem was not in the boot order, but in the fact that the boot information was on the disk I wanted to remove. I have solved the problem. –  Kornelije Petak Apr 26 '11 at 6:33
add comment

Run msconfig /boot and set Windows as the default OS .

If you have already done that you can use a open-souce boot loader like Grub included with most Linux.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.