Router page not opening

Question

When I try to access my router page at 192.168.0.1 (my default gateway) I get the folowing error message:

My Error

I haven't changed anything in my router's configuration recently and I'm pretty sure that 192.168.0.1 is the default gateway. Any suggestions?

"pretty sure" or positive about that gateway? Do an ipconfig (looks like you are using windows, but can't tell for sure) and see. 192.168.1.1 is equally common these days for routers.
you could run the following in cmd: ipconfig/release and after that is done ipconfig/renew

8088 · Accepted Answer · 2011-05-02 18:41:49Z

up vote 1 down vote accepted

First you can try the following in a Command Prompt:

ipconfig /release

After this is done, type the following:

ipconfig /renew

If the above did not work you should restart your router and try to access the router webpage again.

P.S. If the problem persists it might be a time for a new router.

edited May 2 '11 at 18:41

8088
6,13672445

answered May 2 '11 at 18:02

Darius
1,0292720

1

thanks @Gareth for cleaning up my post. – Darius May 2 '11 at 20:39

Justin Pearce · Answer 2 · 2011-05-02 18:04:07Z

up vote 1 down vote

If this is a home router, have you tried removing it's power for 30 seconds and reconnecting power?

answered May 2 '11 at 18:04

Justin Pearce
1,472311

Mark Johnson · Answer 3 · 2011-12-08 03:53:15Z

If it's functional apart from the issue of getting into the management interface (You can get out to the internet), from a computer connected to it:

Make sure it's actually at 192.168.0.1. Try 'route print' from a command prompt and look in the Gateway column of the IPv4 Route Table.
Power cycle it (unplug it, count to 10, plug it back in).
Try to ping it. From a command prompt: 'ping 192.168.0.1' or whatever address you found from 1.

migrated from stackoverflow.com May 2 '11 at 16:50