Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

What happens if I do not plug it into the motherboard and it does not have a switch?

I have seen fans before with an "off/low/high" switch that allows you to manually set their speed.

I have seen fans that plug into the motherboard and are controlled by the OS.

I am curious... what does a fan do by default when plugged into a PSU? Does it run at 100% unless otherwise told to go slower? This is what I would expect...

share|improve this question

4 Answers 4

up vote 13 down vote accepted

Well, kind of. Fan speed control is done by varying voltage or through Pulse Width Modulation (using a constant voltage and cutting it up into pulses to vary speed). If you're plugged into a motherboard, that's what it does. If it has 3 wires, the third wire tells the motherboard what's the speed the fan is running as. If you have a 4th wire, fan speed control is done via PWM rather than voltage control.

You can plug in a 2 wire fan to a 3 or 4 wire connector (though you lose speed feed back), and a 3 wire to a 4 wire connector (where you lose PWM control). You can also use a fan controller to control speeds.

Else, assuming the power source is unaware its a fan (as it would be connected through molex for example), and is at a fixed voltage, yes, it goes are full speed all the time.

share|improve this answer
    
Perfect, just the answer I was looking for. –  darkAsPitch May 26 '11 at 12:54

There are some fans, especially the ones that advertise as "quiet" or "silent" that have interchangeable resistors which decrease the voltage from the PSU molex connector. One of these fans I believe is Noctua. Although expensive, they make high quality fans.

share|improve this answer

Like the other guys said, pretty much yes, but I can think of 3 exceptions:

  1. A few fans have a built in thermistor that will adjust speed depending on temperature.
  2. PSU's with specially marked Fan-Only PSU connectors (Antec TruePower 550W) can adjust the speed of the fan:

    enter image description here

  3. If you plug it into the PSU molex using the 12/5 volt rails (7 volt) or 12/7 rails (5 volt) it'll be run slower, but at this point you're modding.
share|improve this answer

That's pretty much it - if the fan just has a power connector for one of the plugs on the PSU it will run at full speed all the time unless you fit a controller unit.

enter image description here

Full speed ahead!

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.