Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I'm attempting to install Ubuntu Server 10.04.2 i686 on a very old Dell Latitude. The network card I have to use for it is a "Xircom RealPort Ethernet 10/100+Modem 56" PCMIA card.

During install, the card works fine and the installer can fetch packages from the internet. Of note is that I have to remove and reinsert the card for it to be detected properly.

When I install Ubuntu to the HD, the card stops working entirely. The kernel module xe which I think was allowing it to work in the installer is not loaded or even installed to the kernel on the HD. ifconfig shows only the loopback.

How can I get this card to work when Ubuntu is installed? Thanks.

share|improve this question
add comment

1 Answer

It might be udev that messed up things when you reinserted the card. Run ifconfig -a to show all interfaces. Take a look at /etc/udev/rules.d/70-persistent-net.rules end see if it mentions any of the interfaces.

If something looks strange, edit it. E.g. if it has configuration for eth0, but ifconfig -a lists eth1, you could try duplicating the existing rule, rename the interface to eth1, then reboot.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.