up vote 2 down vote favorite
share [g+] share [fb]

I have a debian 3.0 woody installation. I have eth1 and eth0 being randomly switched at reboot. I cannot figure out how to set a manual way to make this always associate to that network card. It is essentially switching network cards at boot which causes a lot of problems.

Any help would be appreciated.

link|improve this question
100% accept rate
feedback

1 Answer

up vote 2 down vote accepted

Try one of the methods suggested here: http://www.science.uva.nl/research/air/wiki/LogicalInterfaceNames

The most natural one (using udev) is probably not available on a woody system.

link|improve this answer
feedback

Your Answer

 
or
required, but never shown
discard

Not the answer you're looking for? Browse other questions tagged or ask your own question.