Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I want to use a large SSD to install system on it and also use it for Intel Smart Response caching?

Start with 120G SSD and 1TB HDD

Take a 120G SSD and split it into 100G and 20G partitions.

Install system on 100G SSD disk

Enable Intel Smart Response for HDD using remaining 20G on SSD.

End result: Fast boot times and program loading from SSD and accelerated game loading from HDD! Computing nirvana! :)

I am using GA-Z68MA-D2H-B3 for mother board.

share|improve this question
    
Someone had answered yesterday, but now the answer is gone. Did the answer was removed because it was downvoted. –  xsaero00 Aug 17 '11 at 16:03

1 Answer 1

up vote 2 down vote accepted

I went ahead and tried it yesterday with 120 GB SSD. The answer is: it is possible. It was a bit complicated and I think it can be simplified but here is how it was done.

The gist of it is that first you follow the Intel guide and configure everything then you wipe OS from HDD and reinstall it onto left over part of SSD.

  1. Install both SSD and HDD into system and turn on RAID mode.
  2. Install OS on the HDD.
  3. Install all necessary drivers, namely the storage drivers
  4. Configure Smart Response. I used only 20G for the cache. This will split the SSD into two partitions. What's interesting is that the cache partition will be the second partition, which works out nicely for OS install
  5. Boot from installation media again and start setup process
  6. Wipe HDD partition and reinstall OS onto large SSD partition.
  7. Install drivers and Smart Response utility and verify that HDD is still "accelerated"

That's it.

There are couple things that I am not sure about. First, whether TRIM is enabled for OS SSD partition in such configuration. Second, I think that first system installation was not necessary, and the whole caching could have been configured using BIOS utility. After I configured the caching, the computer started showing RAID config every time it boots and there is Ctrl + I shortcut to re-configure it.

Anyways, I believe this is the best possible setup for any workstation. On the second thought, you could put couple more HDDs to make it RAID 5 and then accelerate it using Smart Response.

share|improve this answer
    
Could you post a link to the Intel guide you refer to? I haven't seen it in my searches and it may help me with an issue I've been working on. –  SeanKilleen Nov 27 '11 at 14:18
1  
Added the link. –  xsaero00 Dec 29 '11 at 22:19

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.