Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

At my workplace we have USB microphones attached to PCs in high traffic areas. We are looking for a lock to put on the USB port so that will hold the mic in place. This doesn't even need to be locked, just tamper-proof so that it would be a hassle to detach.

Has anyone seen a product that would work for this solution?

share|improve this question

migrated from serverfault.com Sep 22 '11 at 21:36

This question came from our site for professional system and network administrators.

2  
Duct tape, perhaps? XD –  Justin Pearce Sep 22 '11 at 21:41
2  
May I ask why the USB port needs to be out in the open and not concealed? –  digitxp Sep 23 '11 at 2:50
2  
How about a post-it saying "I licked this" –  dpatchery Sep 23 '11 at 19:25
add comment

5 Answers

enter image description here

There are internal USB ports, get something like an internal USB adapter and remove it from the bracket or use an internal USB expansion module. Either mount the USB adaptor internally, or permanently fix it to a USB extension cable (cable tied to the inside of the case), and route it through a suitable office. If a headset dies, you're just out a usb extension cable and the dead headset

share|improve this answer
    
+1 Many USB cards have an interal port This is one ca.startech.com/Cards-Adapters/USB-2/Card/… It hides teh USB drive away and many cases can be locked easily –  Dave M Sep 28 '11 at 20:12
add comment

Have you tried superglue?

enter image description here

Heck, there are even ways to remove superglue: How to Remove Super Glue

share|improve this answer
1  
+1 but I'd weld it –  lukas Sep 23 '11 at 2:11
    
Glue mold to the USB connector, make it look so disgusting that no one would want to touch it let along steal it... –  Silverfire Sep 23 '11 at 2:50
add comment

How about the NZXT Bunker Secure USB 2.0 Drive Bay? $24.99

http://www.legitreviews.com/article/1537/3/

enter image description here

The above image doesn't look like this would do anything for you, but the below image reveals how this could be helpful.

enter image description here

share|improve this answer
add comment

Although I like the superglue answer I can just imagine the IT guys pain when he needs to replace a broken headset.

I'd suggest a couple different things. One is an all in one type of case like Dell sells with the small form factor OptiPlex workstations. You can plug the device into the back and then put on the cover which can be secured.

The other option is to get a small lockable box with holes in each end. The holes would actually be slots so that when the lid is opened the wire can be pulled out (up). Attach the box to the desk and run a USB extension cable from the workstation to the box. Plug the headset into the extension cable and then close and lock the box.

share|improve this answer
add comment

Perhaps Conducting Glue

picture of wire glue

share|improve this answer
1  
How would this work? Wouldn't it effectively cross the USB leads? –  Paperjam Sep 23 '11 at 7:30
    
You would only glue the outer shell, which is connected to ground. –  drxzcl Sep 23 '11 at 9:08
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.