up vote 0 down vote favorite
share [g+] share [fb]

I have a Buffalo WZR-HP-G300NH and a 3TB Western Digital MyBook Essential that I wish to use as a NAS, I have formatted the drive with a single XFS partition, but when I plug it into the router the Disk Management page says "No identifiable partitions."
Any help would be greatly appreciated
Thanks
Ben

link|improve this question
Just to check: you're using the stock firmware (which is claimed to support XFS) and your drive has a GPT partition table and the partition works fine under *nix? – billc.cn Oct 22 '11 at 22:23
Hello, yes, I have used Ubuntu to format it, and it works fine in that using GPT/XFS – Ben Oct 23 '11 at 6:15
I am also using FW 1.77 – Ben Oct 23 '11 at 6:31
feedback

1 Answer

up vote 1 down vote accepted

Buffalo have since confirmed that this router only supports external drives up to 2TB.

link|improve this answer
feedback

Your Answer

 
or
required, but never shown
discard

Not the answer you're looking for? Browse other questions tagged or ask your own question.