If I configure my network card in linux to use DHCP then restart the networking init script, it gets stuck after showing
* Running /etc/init.d/networking restart is deprecated because it may not enable again some interfaces * Reconfiguring network interfaces...
But if I restart networking with the following steps
dhclient -r rmmod be2net /etc/init.d/networking stop modprobe be2net /etc/init.d/networking start
or just reboot the blade then everything works fine.
Also it is unable to detect any DHCP servers running in the network during PXE boot time. Most probably the NIC drivers of my hp blades are not properly configured.
Please suggest a solution to this problem.