Super User is a question and answer site for computer enthusiasts and power users. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

Possible Duplicate:
How to reset a Fritz!Box DSL router to factory settings?

I need to change the setting of router Fritz Box. The setting were set by another person. I can't connect to router using cable, may be standard port or address were changed. So the only option is to switch to factory settings. Usually there is a button which deletes all the settings. I read the documentation and they tell to call the number #991*15901590* on the router. Do I have to connect telephone to router?

share|improve this question

marked as duplicate by 8088, Sathya Nov 11 '11 at 10:54

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

What model is it that you have? – MaQleod Oct 26 '11 at 22:26

Connect to the router via Ethernet or WiFi and negotiate an IP address via DHCP (most Operating System configurations will do that automatically). The Fritz!Box should now be set as the default gateway. You can use route on the command line to determine it.

If DHCP doesn't work anymore, you can still scan the whole private IPv4 address range. For example, nmap -sP will list a Fritz!Box without a configured DHCP server (but functioning IPv4).

share|improve this answer
DCHP seems to be not working. And how can I connect if I don't know the subnet? – damluar Oct 26 '11 at 22:33
@damluar If DHCP isn't working, it's seriously messed up. How did you find out that that's the case? If you watch the incoming packets with wireshark, do any Ethernet packets come in? – phihag Oct 27 '11 at 9:10
I just looked at wireshark. No DHCP Offer comes in response to DHCP Discover – damluar Oct 27 '11 at 11:15

No matter how the FritzBox is configured, it is always reachable via ethernet cable - there you'll find an option to reset to factory settings.

share|improve this answer
In documentation it's written that it's available from But it's not in my case. – damluar Oct 27 '11 at 6:52 is the standard address (factory setting or after a reset). is always available, too. To reach that address, your interface on the desktop must be in the same subnet, and it works only via ethernet cable. – ott-- Oct 27 '11 at 11:23
Not available. Checked 1 hour ago – damluar Oct 27 '11 at 12:28
What model is that FritzBox. You could also connect a phone to the RJ-11 connector, then dial that #991*15901590*. – ott-- Oct 27 '11 at 14:29

Not the answer you're looking for? Browse other questions tagged .