I've installed arch linux on my laptop and i can't configure power profiles or see the battery state. On SLED and openSUSE it works well.
My modules and daemons:
MODULES=(acpid acpi-cpufreq cpufreq_ondemand cpufreq_powersave)
DAEMONS=(syslog-ng network crond laptop-mode @cpufreq appset-helper)
I've tried steps at this site. But i think i haven't done it well. What do i miss?
I use HP ProBook 4530s, drivers are available only for SLED :/
[root@myhost /]# acpi -V
Battery 0: Unknown, 97%
Battery 0: design capacity 4381 mAh, last full capacity 4381 mAh = 100%
Adapter 0: on-line
Thermal 0: ok, 0.0 degrees C
Thermal 0: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 1: ok, 0.0 degrees C
Thermal 1: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 2: ok, 0.0 degrees C
Thermal 2: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 3: ok, 25.0 degrees C
Thermal 3: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 3: trip point 1 switches to mode passive at temperature 55.0 degrees C
Thermal 4: ok, 50.0 degrees C
Thermal 4: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 5: ok, 39.0 degrees C
Thermal 5: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 6: ok, 56.0 degrees C
Thermal 6: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 6: trip point 1 switches to mode passive at temperature 108.0 degrees C
Thermal 7: ok, 60.0 degrees C
Thermal 7: trip point 0 switches to mode critical at temperature 128.0 degrees C
Thermal 7: trip point 1 switches to mode hot at temperature 84.0 degrees C
Cooling 0: LCD 0 of 20
Cooling 1: LCD 0 of 20
Cooling 2: Processor 0 of 10
Cooling 3: Processor 0 of 10
Cooling 4: Processor 0 of 10
Cooling 5: Processor 0 of 10
