Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Possible Duplicate:
How do I make Windows 7 boot further than a blank screen with only a mouse cursor?

While installing Autodesk Inventor 2010 on my Windows 7 laptop, my system froze.

Since that incident, it won't start again. I end up on a black screen with only the mouse visible. The same happens in safemode. I already tried the ideas mentioned on How do I make Windows 7 boot further than a blank screen with only a mouse cursor? without success... Any ideas?

share|improve this question

marked as duplicate by Ƭᴇcʜιᴇ007, slhck, 8088, Dave M, Mokubai Nov 14 '11 at 19:03

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

    
did not see that, but it does not help at all^^ –  Urinprobe Nov 14 '11 at 14:33
    
What have you tried that was listed there in the various answers? –  Ƭᴇcʜιᴇ007 Nov 14 '11 at 14:35
    
yup, none of that works for me... –  Urinprobe Nov 14 '11 at 14:36
1  
Would be good to edit your question and add a list of what you've tried and that you've seen the duplicates, so it won't get closed. –  slhck Nov 14 '11 at 14:39
    
Perhaps update your question with all that you've tried (and the results) so that there will be a better chance that this will be considered a different question (doubtful). Otherwise consider adding a bounty to the other question to garner better answers. –  Ƭᴇcʜιᴇ007 Nov 14 '11 at 14:39

1 Answer 1

I would see if the computer can boot in safe mode, if it does. See if you can uninstall autodesk.

share|improve this answer
1  
Quote from the question: > The same happens in safemode –  slhck Nov 14 '11 at 14:30
    
as I said, safemode does not help, is gets stuck at the same place –  Urinprobe Nov 14 '11 at 14:30

Not the answer you're looking for? Browse other questions tagged or ask your own question.