Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

On many hard drives, there's a text warning to "not cover this hole", sometimes adding that doing so will void the warranty.
What is the purpose of this hole and why would covering it cause damage or increase the likelihood of drive failure?

Do not cover this hole (Image source)

share|improve this question
I especially appreciate that you took a picture of a MacBook Pro where the ribbon cable to the front infrared board and sleep sensor generally covers "THIS HOLE" but presumably not in an air tight manner. –  bmike Dec 16 '11 at 23:14
Hardware geek questions get all the up votes! –  Moab Dec 17 '11 at 1:12
It has a nice picture :-) –  queueoverflow Dec 17 '11 at 11:39
By the way, if you ever build one of those silent oil-submerged computers, DO COVER THIS HOLE! –  wim Dec 19 '11 at 2:27
You'll need a snorkel to extend the hole to an uncovered position. –  XTL Mar 7 '12 at 12:47

2 Answers 2

up vote 145 down vote accepted

It allows for equalization of air pressure between the inside and outside of the drive. While it is not a complete pass-through of outside air into the HDD internals, there is a diaphragm filter inside the hole that allows the air pressure to equalize.

If the drive were completely sealed, operating at altitudes significantly different from those the drive was manufactured and sealed at would cause problems and increase the likelihood of catastrophic failures.

This system works in much the same way as the eustachian tubes that allow our ears internal pressures to equalize, preventing the explosion of our ear drums.

UPDATE: Per Moab's correction, it's a filter, not a diaphragm. The way it works and the reason it is included remains the same.

share|improve this answer
Its a filter not a diaphragm, at least on the few hundred I have disassembled. Air actually does move in and out of the hard drive when temps vary. –  Moab Dec 16 '11 at 21:07
Color me educated. It's been several years since I took one apart and so could not recall clearly. –  music2myear Dec 16 '11 at 21:31
Here is an excellent teardown of a HDD and a description of how it works (including the filter.) –  Andrew Lambert Dec 16 '11 at 22:09
@Moab: Meh, the fact that you call them super magnets makes you a real nerd for all intents and purposes. –  surfasb Dec 17 '11 at 3:49
@jfgagne I'm not sure your numbers are going the right direction: If pressure decreases, any given volume of air would increase as the altitude rises. Using your 20% number, that would mean that 20cc of air at sea level would be 24cc at "airplane elevation". This is further illustrated by snack bags, which expand at altitude. –  music2myear Dec 27 '11 at 14:21

Check out the Wikipedia hard drive entry paying attention to the Integrity section with reference to the "breather hole":

Hard disk drives require a certain range of air pressures in order to operate properly. The connection to the external environment and pressure occurs through a small hole in the enclosure (about 0.5 mm in breadth), usually with a filter on the inside (the breather filter). If the air pressure is too low, then there is not enough lift for the flying head, so the head gets too close to the disk, and there is a risk of head crashes and data loss. Specially manufactured sealed and pressurized disks are needed for reliable high-altitude operation, above about 3,000 m (9,800 ft).[99] Modern disks include temperature sensors and adjust their operation to the operating environment. Breather holes can be seen on all disk drives—they usually have a sticker next to them, warning the user not to cover the holes.

share|improve this answer
Dennis, you can link to sections of Wikipedia articles by using their anchors: en.wikipedia.org/wiki/Hard_disk_drive#Integrity –  iglvzx Dec 16 '11 at 20:56
@iglvzx - Fixed, thanks. I assumed there was a way but hadn't done it yet, easy enough, I'll make note of it. –  Dennis Dec 16 '11 at 20:59
@Dennis: The easiest way would be to use "Copy link location" on the article's table of contents –  grawity Dec 16 '11 at 21:33
It's from Wikipedia .. so it must be true. –  Pure.Krome Dec 20 '11 at 22:59
Only if it's not {{citation needed}}. –  XTL Mar 7 '12 at 12:48

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.