Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have several laptops in the house, plus a desktop that has wired internet. (The laptops are wireless) The desktop's internet speed is normal, but on the laptops really sluggish. It can barely load a webpage. The laptops are in different places around the house, but they are all slow so I don't think it has to do with how far away they are from the router (ASUS DSL - N13).

Any clues on what it might be?

share|improve this question

1 Answer 1

Some standard things to try:

  • Try a different channel. And if everyone stuck to channels 1, 6, and 11, the world would be a better place. There are network-scanning tools like inSSIDer that help you visualize which channels are most busy where you are.
  • Try disabling wide (40MHz) channels. If you're in an area where you can barely find a single 20MHz-wide channel that's free enough to use, then trying to use a double-wide channel is probably just going to make you run into more interference.
  • Try disabling other sources of 2.4GHz interference around you, such as Bluetooth, Wii Remotes, wireless speakers (including subwoofers), wireless webcams/security cams, wireless room-to-room A/V senders, cordless phones (some labeled 5.8GHz actually use 2.4GHz as well), microwave ovens, etc. etc.
  • Re-enable the B and G rates if you previously disabled them. Even N gear uses B and G rates for best performance at range, so it's a bad idea to disable those rates.
share|improve this answer
    
I am ignorant of "if everyone stuck to channels 1, 6, and 11, the world would be a better place" -- please clarify. –  Mr.Wizard Dec 24 '11 at 17:48
    
Channels other than 1, 6, and 11 spill over onto 1, 6, and 11. So if you use, say, channel 4, you'll likely harm channel 1 as much as if you were using channel 1 and you'll harm channel 6 as much as if you were using channel 6. –  David Schwartz Dec 24 '11 at 21:22
1  
@Mr.Wizard The 2.4GHz Wi-Fi channels each overlap several nearby channels. 1, 6, and 11 are far enough apart that they don't overlap each other. So if you only have 3 networks in range of each other they should be on 1, 6, and 11. If you have a fourth network in range it's better to re-use one of 1, 6, or 11, because same-channel interferers are dealt with more efficiently by the 802.11 protocol than partially-overlapping-channel interferers. –  Spiff Dec 24 '11 at 22:15

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.