Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I've got a few hard discs that I'd like to put in some sort of redundant configuration. Their sizes are:

  • 600 GB
  • 1 TB
  • 2 TB

I'm not sure if this is possible, but I'd like to be able to abstract the whole setup to look like a single drive in Windows (but with redundancy so I can recover data if a hard drive fails).

How would people recommend I use these hard drives? Is there a RAID configuration that would allow me to do what I want? How much available space would I have after the space used for redundancy is taken into account?

Note: I have an Intel G33 Express chipset with ICH9R, which supports Raid 0, 1, 5, and 10. I'll be running Windows 7 as my primary OS (Windows 7 will be installed on a separate disc - a small SSD)

share|improve this question
    
What hardware and software is available to you? –  David Schwartz Dec 28 '11 at 3:38
    
@DavidSchwartz, edited to elaborate on your question –  Eric Dec 28 '11 at 4:04

2 Answers 2

up vote 3 down vote accepted

Assuming you meant 600GB, not 600MB. If you still have a 600MB HD time to recycle it.

Most OSes will allow you to create a 1TB and 0.6TB partition on the 2TB drive, then mirror those partitions to the two other drives. This will only give you 1.6TB of usable redundant space, and another 0.4TB of non-redundant space. It's less than ideal, but will afford you some level of redundancy.

share|improve this answer
    
Thanks +1. And yeah 600GB - Fixed –  Eric Dec 28 '11 at 4:05
1  
Install Windows; open Disk Management, convert the drives to Dynamic if necessary. Create mirrored partitions (start each mirror by selecting the smaller 1TB and 600GB disks and place the mirror on the larger disk). Optional: create a 400GB non-redundant partition. You can also mount these as subfolders of another drive so you don't end up with C: D: E:... unless you want those. –  Chris S Dec 28 '11 at 4:48

if you use 2 tb and 1 tb in raid 1. then you can able to use only 1 tb for usage.

if u want use for backup the data go for raid 1.

you cannot make use 600mb in raid. if u try to configure raid 5 with 3 disk it will take 600mb from each and able store 1.2 gb space. you cannot create raid 1 with 3 .

you can try raid 1e

share|improve this answer
    
OSes can apply RAID to partitions in addition to disks. What you describe is limited to conventional HBAs. It would help if you explained what RAID1E is too... –  Chris S Dec 28 '11 at 4:46

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.