Extend wireless from tomato to dd-wrt over ethernet cable

Question

I have a tomato router upstairs (192.168.1.1 connected to modem for internet) and a dd-wrt router (192.168.1.2 connected to .1) downstairs. I have cat-5 running between the two routers. I would like my dd-wrt router to act like a switch (and accept more devices via ethernet) and also extend my wireless range. I am confused on the best way to do this. I don't think I want a bridge or an access point because the routers are connected via LAN, and all tutorials seem to be about extending wireless without a LAN connection. I also don't want 2 different SSIDs. I want 2 routers acting as a team on one network.

My current solution is just to have both routers using the same wireless settings (matching SSIDs) but I don't notice any wireless boost with this method.

Can anyone walk me through this setup?

Thanks a bunch

Answer 1

With your current setup, the upstairs LAN, upstairs WIFI and downstair LAN all form the same layer 2/3 network. Ie, all the devices should be within the 192.168.1.0/24 network.

Provided you are only running DHCP on the upstairs router, you should be able to achieve "accepting more devices via ethernet" right now without doing anything. Ie, plug something into one of the other LAN ports on the dd-wrt router (this assumes that you have connected the two routers via their LAN ports, rather than using the WAN port on the dd-wrt router - if you haven't then this is what you should do), and it should pick up an IP address from the upstairs DHCP server and connect to the internet and all the other devices on the network.

Equally, the default setup for wifi on a router is for it to be bridged to the LAN ports, so again, just enabling wifi on the dd-wrt router should be enough to it to work, and yes it should be configured in AP mode.

You can leave the SSID the same as the upstairs router, but it is important that you choose a different channel. Choosing betwen 1,6 and 11 is best (for 802.11g) as these have minimal overlap. For 802.11n, you can usually leave channel selection to Auto and it will work out the best channel selection. If you are using 802.11n in a "busy" area with lots of other APs, then don't enable 40Mhz bandwidth, leave it at 20Mhz. This will reduce throughput, but also reduce interference. If you have 5Ghz radios, then you can often leave it at 40Mhz as these are less common.

Answer 2

What you need to do on the second AP is disable the wan connection and the dhcp server. You also need to change the default LAN IP to a one which you are not currently using on your network, and which is also outside of the DHCP range on your first AP. Next, in the VLANs tab, switch the WAN port from vlan1 to vlan0 (assuming you have the default settings). This should bridge all the ports on the router. Then you can plug the ethernet cable from the first AP into any port you wish. This is the simplest possible way to do this.

One more thing. Don't expect roaming to work seamlessly. It is pretty much guaranteed that you will lose some packets while switching from one AP to another.