Super User is a question and answer site for computer enthusiasts and power users. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

I have a wireless network at home, to which I connect using a laptop and a desktop. Everything has been working well for several months, but recently my desktop (WinXP) developed a problem: it drops the network connection, then reconnects, then a few seconds later drops it again, reconnects, etc.

The signal strength shows up as "Excellent". The laptop (Win7) still connects to the network without any trouble. So I would have guessed that the wireless card in the desktop has gone on the fritz... except that my workaround seems to be rebooting the router! Whenever this starts happening, I just reboot the wireless router, and now the desktop connects and stays connected... until the same problem recurs a couple of days later.

Any ideas what might be going wrong here?

share|improve this question
Did you confirm that it is the network connection between the computer and the router that drops? For example, did you try pinging the router and confirming that it fails? – David Schwartz Jul 18 '13 at 0:28
@DavidSchwartz - thanks for reminding me of this problem. I posted my solution below. – Shaul Behr Jul 18 '13 at 7:05

Most likely it is a problem with access point which now has to be reset and probably firmware upgraded and reset again.

share|improve this answer

I have the same problem. When the network is up (after you rebooted the access point) try to open a command prompt and ping the router indefinitely.

ping -t ip_of_access_point

If that works and the connection stays alive probably the Access Point capacitors are exhausted and the AP need to be fixed or replaced.

share|improve this answer

Do a wireless survey several times. You may have a nearby Access Point that is conflicting with your AP. See if you can find an unused channel and set your AP to that. Most APs automatically select and then there can be conflicts. HeatMap works well as does Netstumbler. It is important to do this several times, especially at times when you have an issue.

Resetting your AP may change channel so that does a temporary fix.

You should also be sure the AP has clean power. Small dips in voltage can cause issues. A small UPS can address this.

share|improve this answer
up vote 0 down vote accepted

There was a problem with the router. I got a new one and the problem has disappeared.

share|improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .