Tell me more ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.
up vote 1 down vote favorite

  1. If you connect to a router (wireless using encryption -- probably WPA2 in this case), but decided to set your IP yourself not using DHCP, will is still be able to access the network?

    EDIT : Does the same idea apply if I manually configure the ip with ifconfig (linux or osx).

  2. Does is recognize you as a connected user by your MAC address, or by some other authentication mechanism?

share|improve this question
This is usually referred to as "static configuration". – RedGrittyBrick Feb 25 '12 at 11:42

1 Answer

up vote 1 down vote accepted

Yes, you will still be able to access the network, but if you want to access the internet through the router you will need to also set up the "gateway" and "dns" addresses in your manual configuration. You would point these at your router and it would work as if you had gotten an IP address via dhcp. This is irrespective of operating system or tool used to configure the manual setup.

Your computer will probably no longer show up in the 'connected devices' section of your router configuration as this section typically is populated by the devices that have requested an address via dhcp.

While you can restrict access to devices by MAC address, if you have not set this up then you should not have a problem. If you have set up MAC address filtering then as long as your computer is in the list then I would not expect to see a problem even if not using dhcp.

The problem would come if you are using MAC address filtering and your machine is not in the list. Depending on how well the router is configured you may or may not be able to connect to the internet.

If the filtering is done by preventing certain MAC addresses from obtaining an IP address then by going to manually configured you will be able to bypass this protection and potentially still connect to the internet. If the router is set up properly then the filtering will be on the firewall and changing to manual configuration will not allow you access to the internet.

share|improve this answer
so this works with wireless as well, and it doesn't matter if u use encryption or not? – rubixibuc Feb 25 '12 at 9:34
The encryption is the first stage towards a secure connection and happens (I believe) before any actual network negotiation occurs. As far as I know so long as you have the password you should be able to connect to the router, but after that it depends on the router setup as detailed in my answer as to whether or not you will be able to connect to the internet. – Mokubai Feb 25 '12 at 9:41
So effectively, yes, this should work with both wired and wireless connections. Think of the encryption stage of setting up a wireless network as effectively the same as plugging in a wire in a wired network, it provides the substrate for the network to work across. – Mokubai Feb 25 '12 at 9:43
thank you, I didn't realize that :-) – rubixibuc Feb 25 '12 at 9:45

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.