Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I'm in the middle of my first computer build and have hit a brick wall. Having assembles (and re-assembled) all of the components, I'm still getting a POST error (a long beep followed by two short beeps) saying I have no memory. I have tried two different types of memory, both of which are on the QVL for my Asus P8P67 Rev 3.1 motherboard. I every combination of sticks in all 4 slots, clearing the RTC RAM between each attempt and running MEMOK! as well. Everything else seems to run fine; all fines run continuously, hard drives fire up, case lights working, except that the RAM is not detected.

Any suggestions on what I should do? I'd appreciate any advice.

Motherboard: Asus P8P67 Rev 3.1
Processor: Intel Core i-5 2500k
RAM: 2 different versions of G.Skill ripsaw 4gb DDR3 memory, one set at 1333 MHz and one set at 1600 Mhz (used separately)
Video Card: GeForce GTX 560 Ti
PS: Seasonic S12 II Bronze 520W 80Plus Power Supply

Thank you

share|improve this question

1 Answer 1

Try removing all other hardware, including hard drives and video cards.

It's also possible your motherboard is defective.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.