Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I can't find a solid answer anywhere. Can you just not do wireless interface specific stuff in a virtualized Backtrack? All it ever comes up with for network interfaces in backtrack is the ethernet port and the loopback.

share|improve this question
    
put the networking in NT mode, and then you must have the wireless device on your mac recognised. –  HackToHell Mar 20 '12 at 4:20
    
Here is what NAT means virtualbox.org/manual/ch06.html#network_nat Enable it in Setting > Network > Attached to NAT –  HackToHell Mar 20 '12 at 5:38

1 Answer 1

up vote 1 down vote accepted

Short answer: You can certainly do wireless specific things inside a VirtualBox VM, But probably not as easily as you would like.

Long answer: It requires quite a few hoops to jump through. You really need to read the section of the VBox manual for PCI Passthrough. In short, you need to meet these requirements to even try it:

  • IOMMU Hardware support
    • through either VT-d (Intel) or AMD-Vi (AMD)
    • support on your motherboard as well
  • A Linux host (so not inside Mac OS currently)
  • Kernel 2.6.31 or later
  • Hardware assist and nested paging support enabled for guest vm

This will present the physical PCI card to your guest, so you would install the native wireless driver (or use the version that ships with your distro) in your guest. There are also some limits placed on what other VBox features are (not) supported when running with PCI passthrough - again read and understand the relevant section from the manual for this feature.

Note: this is answered for VirtualBox 4.1.10 - past/future versions may be different

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.