Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I've been going through the steps trying to install Arch Linx and I cant get past the network configuration.

I got Arch to recognize my broadband card after following the instructions on Arch Wiki using the brcmsmac module iwconfig shows that the wlan0 device is down. but when I run ip link wlan0 up it just prints and error message over and over again:

ieee80211 phy0: wlc_recv: dropping a frame with invalid src mac address, a2: 00:00:00:00:00:00

Which makes it pretty difficult to continue the install. And I cant redirect the output, its not coming from the ip command. From googling around the best I can tell is that it might be coming from syslog, but I don't really know. Any help appreciated.

share|improve this question
add comment

1 Answer

up vote 1 down vote accepted

It's a kernel message, most likely printed by the kernel itself – you can stop these from being printed to the console with dmesg:

dmesg -n 1
share|improve this answer
    
Perfect, thanks a ton! –  Joshkunz Mar 24 '12 at 17:00
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.