Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I am hacking around with an old (CRT) VGA monitor.

What I want is to make the monitor display a blank white screen at all time, when the power is connected of course. I do not care if I cannot use my monitor for its normal job anymore.

Is it possible to short some pins of the VGA connector to mimic a blank white screen?

Or should I go to http://electronics.stackexchange.com?

share|improve this question
    
Out of curiosity - why? (I personally have no idea how to do this short of leaving a computer connected SHOWING a solid white screen all the time, so I'll decline answering.) –  Shinrai Mar 26 '12 at 15:46
1  
You can make an oscilloscope from an old crt, but mine shows a message and automatically shuts of :( and I don't want to keep a computer connected. But I am not familiar with the VGA connector protocol. –  Qurben Mar 26 '12 at 15:51
    
Ooooh, that sounds like fun. Good luck with that. –  Shinrai Mar 26 '12 at 15:53
    
Thank you very much! –  Qurben Mar 26 '12 at 15:54
    
Shorting some pins on the VGA connector won't do what you want. The VGA interface includes timing signals, e.g. horizontal & vertical sync pulses. Nothing will be displayed until the monitor can recognize frequency of the pulses. BTW a white screen will cause the monitor to draw maximum electrical power from the AC line. –  sawdust Mar 26 '12 at 19:25

2 Answers 2

Disclaimer: I am not a monitor technician nor do I work for or am affiliated with the linked company.

The easiest solution (but not the cheapest) is to obtain a VGA monitor tester. They usually have solid color generation functions, and white (as a comment mentioned) is also to test maximum power draw. These can be found ranging from $25 to many hundreds of dollars. For example: http://www.datasynceng.com/vgapdoc.htm

If you want to build your own, it might be less expensive since you only want one function. For that, you'll definitely want to look at the VGA specification (see references), VGA pinout, and of course consult the electronics gurus at Electronics SE.

Related or useful:

share|improve this answer

All LCD monitors have a white light source behind the panel. You can use this. Forget about delivering a display signal and just figure out what kind of power you need to get just the backlight working.

Tear out all electronics and replace it with a simple power supply that is only connected to that backlight. Done :-)

yeah I know it's a bit late to answer. Care to tell how it turned out?

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.