Super User is a question and answer site for computer enthusiasts and power users. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

Possible Duplicate:
How can I configure dual headphones under Windows 7?

Here is my scenario. I have a Windows 7 machine. This machine has two wireless headsets (I have two wireless dongles and two headphones). I am playing a movie and what I want to do is have the sound come out of both headsets. Right now I can have the sound come out of one or the other, but not out of both simultaneously. Is there a way to do this in Windows 7?

share|improve this question

marked as duplicate by studiohack May 6 '12 at 19:34

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

This is not a duplicate question. I don't have any laptop or output jacks like this question involves – Icemanind May 6 '12 at 20:29
up vote 0 down vote accepted

If you are using the 1/8" stereo jack in a sound card or the built-in motherboard audio output, stereo y-cables are available. Plug the y-cable male jack into the audio output and each headset into the y-cable female sockets. It should work with any sound card.

Edit: Original question didn't identify the dongles. Since mine are analog, the answer given matches my experience. Dongles since identified to be USB sound card devices. Windows 7 doesn't support splitting the audio stream between two sound cards for simultaneous output from both via OS settings. Usually when you want this kind of behavior, you use Virtual Audio Cable.

share|improve this answer
They are wireless headsets – Icemanind May 6 '12 at 19:26
Then use a wireless Y cable ;) – Daniel R Hicks May 6 '12 at 19:33
Dongles mentioned, do they plug in? Then wireless is only between the dongle and the headset. – Fiasco Labs May 6 '12 at 19:35
The dongles are just little devices that look similar to a USB drive. They plug into a USB port. The actual headset is here – Icemanind May 6 '12 at 20:26
Better formulation of original question was needed. So how do they appear to the operating system. As a virtual sound card or speakers. Wherever this question is duplicated at, you need to reformulate your question so you will get a clearer answer. As this one is closed, over and out. – Fiasco Labs May 6 '12 at 21:09

I do it a little different. I have a couple desktops, one set of monitor speakers, and a couple headphones now and then. Little different scenario, but I think my solution would work, though it's not a Windows 7 solution per se.

I use a small mixing board.

In your case, take your sound output, run to the mixing board. The mixing board should have a number of options for sound output. You could run the stereo mix to your main computer speakers (if you roll that way), and plug any number of other devices (your headphones) into the headphone out, control room out, stereo sends, etc...

For what it's worth, this is the one I use. May be more mixer than you need, but there's room to grow, and they're not too terribly expensive. A smaller sibling here is tiny, but actually still has 3 stereo outputs. In any case, there are a number of options from various vendors that can accomplish the basic mixing you're trying to do.

Be careful though, you can get really used to the control :)

share|improve this answer
My sound is wireless though. There are no ports or jacks. What I have is this product – Icemanind May 6 '12 at 20:28

Not the answer you're looking for? Browse other questions tagged .