Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

If I go to Settings-PowerManager->Monitor tab there are (among others) two sliders for management. 1. "Put Display to sleep when computer is inactive for:" 2. "Switch off display when computer is inactive for:"

Whats the difference between putting monitor to sleep/switch it off? I cannot figure it out!

share|improve this question
add comment

2 Answers

up vote 1 down vote accepted

"Put the display to sleep" and "Switch off the display" are different DPMS modes.

There are four DPMS modes:

  • Normal: what your monitor is doing when you're using it
  • Standby: a power saving mode, the screen is blanked by turning the RGB guns off
  • Suspend: another power saving mode, similar to standby, but the power supply to the monitor is also turned off, saving even more power
  • Off: the monitor is actually turned off, except for a circuit that listens for a signal to turn it back on; it uses almost no power, but it takes longer to turn back on than the other power saving modes

There are more technical details, including the watts used in each mode, here.

Xfce's "Put the display to sleep" is either DPMS standby or suspend, I'm not sure which. "Switch off the display" uses DPMS off mode.

Now, these DPMS modes clearly only have meaning for CRT monitors. LCD monitors interpret DPMS signals differently. It might depend on the monitor, but there is probably no difference for LCD monitors. They just turn off if they receive any of the DPMS power saving signals.

Which setting should you use, then? Again, it probably doesn't matter. I would use "Switch off the display", since that's actually what I want my monitor to do. Telling your monitor to go into a CRT power saving mode when you know it's just going to turn off anyway seems a bit backwards to me.

share|improve this answer
add comment

Put display to sleep = put into lower power consumption mode

Switching off display = simply turn screen to black

share|improve this answer
    
In my experience the "sleep" mode is just switching the monitor off as well. (At least it looks like) –  Rafael T Jul 5 '12 at 11:02
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.