I have a Linksys WRT54G as my primary router, and it's hooked into the modem, and everything with that is groovy.
Additionally, I have a NETGEAR WG602 which is meant to give internet to the upstairs floor. It plugs into a cable that goes directly into the WRT via some tubes (no pun intended) in the wall.
However, the WG602 has no internets! I've reset it and the relevant options seem to be what IP address to give it, and whether or not to enable its DHCP client. The WRT54G has an IP address of 192.168.1.1, and the WG602 has a default IP address of 192.168.0.227.
In order to configure it, I've been plugging in directly via an ethernet cable, and setting my own static IP to 192.168.0.25.
I enable the DHCP client and plug it into the WRT-managed network, but it still doesn't show up in the linksys' DHCP client table.
What gives? Any other diagnostic steps I could take?