Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I've got a HP Microserver at home running Windows 7 and it sits behind a BT Infinity HomeHub Router.

Basically I followed the instructions here.

And then on my router I allowed the following to my server:

TCP 1723-1723 1723-1723
UDP 500-500 500-500
TCP 170-1701 1701-1701

However I can't get my phone (Galaxy Nexus) nor my iPad to connect to the VPN. I've done a ping test and I can resolve the IP. I'm using dyndns if that makes any difference, however I direct IP to my home network doesnt work either

Any ideas?

I get these messages on my servers event logs

The following error occurred in the Point to Point Protocol module on port: VPN3-1, UserName: MediaServer\vpn. The remote computer does not support the required data encryption type.

CoId={NA}: The user MediaServer\vpn connected to port VPN3-1 has been disconnected because no network protocols were successfully negotiated.

share|improve this question

migrated from serverfault.com Sep 6 '12 at 22:48

This question came from our site for system and network administrators.

2 Answers 2

I was also getting the following event log system error:

CoId={NA}: The user *** connected to port VPN3-1 has been disconnected because no network protocols were successfully negotiated.

I was able to get rid of the error thanks to K20GH's comment. Here are the steps I followed:

  1. Right-click the network icon in the notification area and select "Open Network and Sharing Center"
  2. Click "Change adapter settings"
  3. Right-click "Incoming connections" and select Properties
  4. On the Networking tab, select IPv4 and click Properties
  5. Select "Specify IP addresses" and enter a range of IP addresses

Android VPN client is able to connect successfully now to my Windows 7 laptop after doing the above.

share|improve this answer

You need to permit the GRE protocol many low-end routers don't support this, or only support this when you set the VPN server as the 'DMZ' device.

share|improve this answer
    
I've added the server as the DMZ device, however the connection gets rejected immediately now –  K20GH Sep 6 '12 at 22:29
    
That is good, now check the event logs on your 'server'. –  Zoredache Sep 6 '12 at 22:32
    
I appear to have these messages - see updated question –  K20GH Sep 6 '12 at 22:38
    
Done it From Network Connections Right Click "Server Name"(local) Select Properties Select IP Tab Under IP address assignment select "Static Address Pool" and assign a pool of ip addresses from within the range of the IP addresses available from the DHCP server. After doing this I am able to connect. –  K20GH Sep 6 '12 at 22:46
    
@K20GH Can you add your solution here as an "answer" so that it can be accepted? –  JoshP Sep 7 '12 at 13:36

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.