Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

My Logitech camera (C300) is properly detected and present at /dev/video0. However, by default the image has contrast and saturation set to maximum, which significantly degrades the image quality. I can change the settings using guvcview but after quitting the settings are back to normal (I am using mplayer to capture frames). How can I make the changes I make in guvcview permanent?

EDIT:

It looks like the guvcview's settings are indeed "sticky" - if I open it again, the image stays the same. So it is something the other programs are doing to the initialisation of the webcam (same problem on mplayer and vlc)

share|improve this question

1 Answer 1

I fixed a similar problem following these steps (adapted from source):

$ sudo apt-get install mercurial
$ hg clone http://linuxtv.org/hg/v4l-dvb
$ cd v4l-dvb
$ sudo make menuconfig <-- dont change anything, just "Exit" and save changes
$ sudo emacs v4l/.config <-- change CONFIG_DVB_FIREDTV=m to CONFIG_DVB_FIREDTV=n
$ make
$ sudo make install
$ v4l2ucp <-- Auto Gain off
share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.