Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Here's my situation:

The home network is

wall <--pluged in modem/router <-- plugged in wireless DD-WRT router via 2 metre CAT5 cable<--- plugged in wireless belkin router, via 10 metre CAT5 cable.

The belkin router is used to extend access to the sleep out I live in.

I occasionally have some kind of network issue, where I have limited connectivity and can't access the internet. Solution seems to be to reset the belken access point. Problem is, the router is housed in my flatmates room, which is usually locked, so I'd like to reset it via browser.

if I do ipconfig, the default gateway shows the IP address of the DR-WRT router, and I can access it fine with my browser.

How can I access the belkin router?

share|improve this question
add comment

1 Answer

up vote 1 down vote accepted

I recommend the following:

    • RouterA: Connected directly to the modem.
    • RouterA: 192.168.0.1 Static IP LAN
    • Router A: Configured for DHCP 192.168.0.0
    • RouterB: Static LAN IP 192.168.0.2
    • Router B: DHCP Disabled
    • Router B: Connected to a LAN port on RouterA

From up PC, you can access the router from the IPs 1 and 2.

share|improve this answer
    
How would I configure router B? Would I have to plugin with an ethernet cable? –  user1068446 Oct 13 '12 at 13:40
    
Exactly, you must configure RouterB using UTP cable using a computer before connecting to the network –  KakashiSan Oct 13 '12 at 14:18
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.