Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have an old lab device which prints it's result to a serial printer. I need to replace the serial printer with a computer. I have connected the device's 9 pin serial port to the computer's serial port, and started hyperterminal with the connection setting as described in the manual. The settings are as follows:

  • Printer interface
  • V.24 ( RS 232 C )
  • 9600 baud
  • 1 start bit
  • 7 data bits
  • 1 parity bit
  • 1 stop bit
  • output only, no control lines.

For some reason hyperterminal does not display any result from the unit. Is there something I am missing? Do I require a special serial cable? If I can get the result in Hyperterminal, I would be able to develop my C# program.

Thank you for your assistance.

share|improve this question

migrated from stackoverflow.com Nov 29 '12 at 2:00

This question came from our site for professional and enthusiast programmers.

    
This is a hardware issue, not a programming issue. Stackoverflow is the wrong place for this question. –  Daniel Mann Nov 28 '12 at 22:34
    
I have previously communicated with other serial devices with c#. For some reason I cannot read the output from the device which is meant for a serial printer. Thus I believe it is either a communication port setup, physical cable setup, or some communication which must first be send to the device to let it know it can transmit. –  user1861429 Nov 29 '12 at 5:07
add comment

3 Answers

up vote 0 down vote accepted

Have you tried a null modem cable? It's a cable that has RX/TX cross connected. A pinout should be published somewhere.

share|improve this answer
    
Thank you for the reply. I have purchased a serial data cable from our local pc store. Would that be a null modem cable, or must I ask specific for it? –  user1861429 Nov 29 '12 at 5:09
    
Thank you for your help, the null modem cable did work. –  user1861429 Jan 7 '13 at 7:11
add comment

If you are trying to simulate a serial device, you could try com0com to set up a virtual serial port.

share|improve this answer
    
Thanks you for your help. I have downloaded it, and will test it today. –  user1861429 Nov 29 '12 at 5:11
add comment

I think what you're after is a Null Modem cable. You may have trouble finding one any more though.

share|improve this answer
    
Thank you for the link; I will use the information to ask the pc shop to make up one for me. –  user1861429 Nov 29 '12 at 5:13
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.