Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have a Windows Server 2008 R2 with native boot inside a VHD. It was running fine with 2 GB of RAM, and I tried to upgrade it to 6 GB. This caused a BSOD, and I haven't been able to fix in unless I remove the RAM.

I've tried several combinations, discarding a possible hardware failure. If I try to put more than 3 GB of RAM, it won't boot.

The host computer is a 32 bit Windows 7 Professional and the computer is a Dell Optiplex 745.

Just to clarify, I'm using a VHD to boot natively into Windows Server.

Any idea?

share|improve this question

migrated from serverfault.com Dec 29 '12 at 16:24

This question came from our site for professional system and network administrators.

1  
Clarify, what are you adding RAM to - the VM, or the physical host? –  HopelessN00b Dec 29 '12 at 0:46
2  
Page 15 of the Optiplex 745 User's guide indicates max memory config of 8GB, at 533/667 MHz, or 4GB at 800 MHz, using 256 MB, 512 MB, 1 GB, or 2 GB non-ECC sticks only -- 2-GB 800-MHz memory modules are not supported. Also, Windows 7 Pro 32bit has a limit of 4GB physical RAM. –  jscott Dec 29 '12 at 0:52
    
@HopelessN00b I've edited the post for clarification. jscott So according with your data, I shouldn't have any problem with this configuration: 2x2GB (800Mhz). –  rlbisbe Dec 29 '12 at 0:54
1  
@rlbisbe Read the User's Guide again, it specifically states "2-GB 800-MHz memory modules are not supported." –  jscott Dec 29 '12 at 1:00
1  
@jscott Write it as an answer so I can mark it :). Thanks –  rlbisbe Dec 29 '12 at 10:21
show 1 more comment

1 Answer

up vote 2 down vote accepted

The Dell Optiplex 745 User's Guide has details of the product's configuration. Of particular interest is page 56, where the memory specifications are detailed:

Memory Type 533, 667, or 800 MHz DDR2 SDRAM

NOTE: 2-GB 800-MHz memory modules are not supported.

Memory connectors 4

Memory modules supported 256 MB, 512 MB, 1 GB, or 2 GB non-ECC

Minimum memory dual-channel: 512 MB; single-channel: 256 MB

Maximum memory At 533 or 667 MHz: 8 GB At 800 MHz: 4 GB

I would appear that using 2GB 800Mhz modules is explicitly not supported. This would most likely explain the BSOD issues you're having.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.